Cookies
Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
ASTM A610-79(2014)
Standard Test Methods for Sampling and Testing Ferroalloys for Determination of Size
Automaticky přeložený název:
Standardní zkušební metody pro odběr vzorků a testování feroslitiny pro stanovení velikosti
NORMA vydána dne 1.10.2014
Informace o normě:
Označení normy: ASTM A610-79(2014)
Poznámka: NEPLATNÁ
Datum vydání normy: 1.10.2014
Kód zboží: NS-3354
Počet stran: 2
Přibližná hmotnost: 6 g (0.01 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Kategorie - podobné normy:
Anotace textu normy ASTM A610-79(2014) :
Keywords:
crushed, ferroalloys, lump, plates, sampling, sieving, size, sizing, ICS Number Code 77.100 (Ferroalloys)
Doplňující informace
| 1. Scope | ||||
|
1.1 These test methods cover procedures for the sampling and testing of the various ferroalloys for sizing, either before or after shipment from the plants of the manufacturers. 1.2 They are designed to give results representative of each lot that will be comparable with the manufacturer's certified analysis for the same lot. 1.3 The purchaser may use any sampling procedure he desires, but the results obtained on such samples shall not be a basis for complaint or rejection, unless the procedure followed is of an accuracy equivalent to that prescribed in these test methods. 1.4 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.4.1 Exception—The SI units that correspond to mesh sizes in Table 1 are to be regarded as standard. 1.5 This standard does not purport to
address all of the safety concerns, if any, associated with its
use. It is the responsibility of the user of this standard to
establish appropriate safety and health practices and determine the
applicability of regulatory limitations prior to use.
|
||||
| 2. Referenced Documents | ||||
|
Doporučujeme:
