Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Specification for Steel, Sheet and Strip, High-Strength, Low-Alloy, Hot-Rolled and Cold-Rolled, with Improved Atmospheric Corrosion Resistance
Automaticky přeložený název:
Standardní specifikace pro ocel , plechy a pásy , vysokopevnostní nízkolegované válcované za horka a válcované za studena, s vylepšenou odolností proti atmosférické korozi
NORMA vydána dne 1.11.2015
Označení normy: ASTM A606/A606M-15
Poznámka: NEPLATNÁ
Datum vydání normy: 1.11.2015
Kód zboží: NS-620461
Počet stran: 4
Přibližná hmotnost: 12 g (0.03 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
alloy steel sheet, alloy steel strip, cold rolled steel sheet, cold rolled steel strip, high strength low alloy steel, hot rolled steel sheet, hot rolled steel strip, steel sheet, steel strip,, ICS Number Code 77.140.50 (Flat steel products and semi-products)
1. Scope | ||||||||
1.1 This specification covers high-strength, low-alloy, hot- and cold-rolled sheet and strip in cut lengths or coils, intended for use in structural and miscellaneous purposes, where savings in weight or added durability are important. These steels have enhanced atmospheric corrosion resistance and are supplied in two types: Type 2 contains 0.20 % minimum copper based on cast or heat analysis (0.18 % minimum Cu for product check). Type 4 contains additional alloying elements and provides a level of corrosion resistance substantially better than that of carbon steels with or without copper addition (Note 1). When properly exposed to the atmosphere, Type 4 steel can be used bare (unpainted) for many applications. Note 1: For methods of establishing the atmospheric corrosion
resistance of low-alloy steels, see Guide G101.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. |
||||||||
2. Referenced Documents | ||||||||
|
Poslední aktualizace: 03.05.2024 (Počet položek: 2 896 946)
© Copyright 2024 NORMSERVIS s.r.o.