Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Specification for Seamless Austenitic Steel Pipe for High-Temperature Service
Přeložit název
NORMA vydána dne 1.11.2019
Označení normy: ASTM A376/A376M-19
Poznámka: NEPLATNÁ
Datum vydání normy: 1.11.2019
Kód zboží: NS-976067
Počet stran: 7
Přibližná hmotnost: 21 g (0.05 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
austenitic stainless steel, central station service, feedwater heater tubes, stainless steel tube, steel tube, welded steel tube,, ICS Number Code 23.040.10 (Iron and steel pipes)
1. Scope | ||||||||||||||
1.1 This specification2 covers seamless austenitic steel pipe intended for high-temperature service. Among the grades covered are H grades and nitrogen grades that are specifically intended for high-temperature service. Note 1: This specification was originally developed for use
for piping in the central stations of electric-power generating
thermal plants. However, its use is not restricted to such
applications and it may be used in other applications for which the
attributes of the materials, as defined by this specification, are
appropriate.
1.2 Optional supplementary requirements (S1 through S10) are provided. These supplementary requirements specify additional tests that will be made only when stated in the order, together with the number of such tests required. 1.3 Grades TP321 and TP321H have lower strength requirements for nominal wall thicknesses greater than 3/8 in. [9.5 mm]. 1.4 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. The inch-pound units shall apply unless the “M” designation of this specification is specified in the order. Note 2: The dimensionless designators NPS (nominal pipe size)
and DN (Diametre Nominel) have been substituted in this standard
for such traditional terms as “nominal diameter,” “size,” and
“nominal size.”
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||||||
2. Referenced Documents | ||||||||||||||
|
Chcete mít jistotu, že používáte pouze platné technické normy?
Nabízíme Vám řešení, které Vám zajistí měsíční přehled o aktuálnosti norem, které používáte.
Chcete vědět více informací? Podívejte se na tuto stránku.
Poslední aktualizace: 02.05.2024 (Počet položek: 2 896 910)
© Copyright 2024 NORMSERVIS s.r.o.