Cookies
Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
ASTM A333/A333M-15
Standard Specification for Seamless and Welded Steel Pipe for Low-Temperature Service and Other Applications with Required Notch Toughness
Automaticky přeložený název:
Standardní specifikace pro bezešvé a svařované ocelové trubky pro nízkoteplotní a další aplikace s požadovanou vrubová houževnatost
NORMA vydána dne 1.11.2015
Informace o normě:
Označení normy: ASTM A333/A333M-15
Poznámka: NEPLATNÁ
Datum vydání normy: 1.11.2015
Kód zboží: NS-622394
Počet stran: 8
Přibližná hmotnost: 24 g (0.05 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Kategorie - podobné normy:
Anotace textu normy ASTM A333/A333M-15 :
Keywords:
low, low temperature service, seamless steel pipe, stainless steel pipe, steel pipe, temperature service applications,, ICS Number Code 23.040.10 (Iron and steel pipes)
Doplňující informace
| 1. Scope | ||||||||||||||||
|
1.1 This specification2 covers nominal (average) wall seamless and welded carbon and alloy steel pipe intended for use at low temperatures and in other applications requiring notch toughness. Several grades of ferritic steel are included as listed in Table 1. Some product sizes may not be available under this specification because heavier wall thicknesses have an adverse effect on impact properties. 1.2 The values stated in either SI units
or inch-pound units are to be regarded separately as standard.
Within the text, the SI units are shown in brackets. The values
stated in each system may not be exact equivalents; therefore, each
system shall be used independently of the other. Combining values
from the two systems may result in non-conformance with the
standard. The inch-pound units shall apply unless the “M”
designation of this specification is specified in the order.
Note 1: The dimensionless designator NPS (nominal pipe size)
has been substituted in this standard for such traditional terms as
“nominal diameter,” “size,” and “nominal size.”
|
||||||||||||||||
| 2. Referenced Documents | ||||||||||||||||
|
Doporučujeme:
