Cookies
Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
ASTM A276/A276M-17
Standard Specification for Stainless Steel Bars and Shapes
Přeložit název
NORMA vydána dne 15.3.2017
Informace o normě:
Označení normy: ASTM A276/A276M-17
Poznámka: NEPLATNÁ
Datum vydání normy: 15.3.2017
Kód zboží: NS-677542
Počet stran: 8
Přibližná hmotnost: 24 g (0.05 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Kategorie - podobné normy:
Anotace textu normy ASTM A276/A276M-17 :
Keywords:
austenitic stainless steel, austenitic-ferritic duplex stainless steel, ferritic stainless steel, martensitic stainless steel, stainless steel bars, stainless steel shapes,, ICS Number Code 77.140.20 (Steels of high quality),77.140.60 (Steel bars and rods),77.140.70 (Steel profiles)
Doplňující informace
| 1. Scope | ||||||||||||||||
|
1.1 This specification covers hot-finished or cold-finished bars except bars for reforging (Note 1). It includes rounds, squares, and hexagons, and hot-rolled or extruded shapes, such as angles, tees, and channels in the more commonly used types of stainless steels. The free-machining types (Note 2) for general corrosion resistance and high-temperature service are covered in a separate specification. Note 1: For bars for reforging, see Specification A314.
Note 2: For free-machining stainless bars designed especially
for optimum machinability, see Specification A582/A582M.
Note 3: There are standards covering high nickel, chromium,
austenitic corrosion, and heat-resisting alloy materials. These
standards are under the jurisdiction of ASTM Subcommittee B02.07
and may be found in Annual Book of ASTM Standards, Vol.
02.04.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. The inch-pound units shall apply unless the “M” designation of this specification is specified in the order. |
||||||||||||||||
| 2. Referenced Documents | ||||||||||||||||
|
Doporučujeme:
