Cookies
Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
ASTM A20/A20M-04a
Standard Specification for General Requirements for Steel Plates for Pressure Vessels (Includes all amendments And changes 8/16/2017).
Automaticky přeložený název:
Standardní specifikace pro všeobecné požadavky na ocelové plechy pro tlakové nádoby
NORMA vydána dne 1.5.2004
Informace o normě:
Označení normy: ASTM A20/A20M-04a
Poznámka: NEPLATNÁ
Datum vydání normy: 1.5.2004
Kód zboží: NS-1557
Počet stran: 33
Přibližná hmotnost: 99 g (0.22 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Anotace textu normy ASTM A20/A20M-04a :
Keywords:
general delivery requirement, pressure containing parts, pressure vessel steels, steel plates, steel plates for pressure vessel applications, ICS Number Code 23.020.30 (Pressure vessels, gas cylinders), 77.140.50 (Flat steel products and semi-products)
Doplňující informace
| 1. Scope | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
1.1 This general requirements specification covers a group of common requirements that, unless otherwise specified in the applicable product specification, apply to rolled steel plates for pressure vessels covered by each of the following product specifications issued by ASTM: 1.1.1 This general requirements specification also covers a group of supplementary requirements that are applicable to several of the above product specifications as indicated therein. Such requirements are provided for use if additional testing or additional restrictions are required by the purchaser, and apply only if specified individually in the purchase order. 1.2 provides information on coil as a source of plates for pressure vessels. 1.3 provides information on the variability of tensile properties in plates for pressure vessels. 1.4 provides information on the variability of Charpy-V-Notch impact test properties in plates for pressure vessels. 1.5 provides information on cold bending of plates, including suggested minimum inside radii for cold bending. 1.6 These materials are intended to be suitable for fusion welding. When the steel is to be welded, it is presupposed that a welding procedure suitable for the grade of steel and intended use or service will be utilized. 1.7 In case of any conflict in requirements, the requirements of the applicable product specification prevail over those of this general requirements specification. 1.8 Additional requirements that are specified in the purchase order and accepted by the supplier are permitted, provided that such requirements do not negate any of the requirements of this general requirements specification or the applicable product specification. 1.9 For purposes of determining conformance with this general requirements specification and the applicable product specification, values are to be rounded to the nearest unit in the right-hand place of figures used in expressing the limiting values in accordance with the rounding method of Practice E 29. 1.10 The values stated in either inch-pound units or SI units are to be regarded as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents. Therefore, each system is to be used independently of the other. 1.11 This general requirements specification and the applicable product specification are expressed in both inch-pound units and SI units; unless the order specifies the applicable "M" specification designation (SI units), the plates are to be furnished to inch-pound units. |
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
| 2. Referenced Documents | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
Doporučujeme:
