Cookies
Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
ASTM A193/A193M-23
Standard Specification for Alloy-Steel and Stainless Steel Bolting for High Temperature or High Pressure Service and Other Special Purpose Applications
Přeložit název
NORMA vydána dne 1.3.2023
Informace o normě:
Označení normy: ASTM A193/A193M-23
Poznámka: NEPLATNÁ
Datum vydání normy: 1.3.2023
Kód zboží: NS-1135555
Počet stran: 14
Přibližná hmotnost: 42 g (0.09 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Kategorie - podobné normy:
Anotace textu normy ASTM A193/A193M-23 :
Keywords:
alloy steel bars, alloy steel bolting, bolting components, bolting materials, hardness, heat treatment, stainless steel bolting,, ICS Number Code 21.060.01 (Fasteners in general),77.080.20 (Steels)
Doplňující informace
| 1. Scope | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
1.1?This specification1.2?Several grades are covered, including ferritic steels and austenitic stainless steels designated B5, B8, and so forth. Selection will depend upon design, service conditions, mechanical properties, and high temperature characteristics. 1.3?The following referenced general requirements are indispensable for application of this specification: Specification A962/A962M. Note 1:?The committee formulating this specification has
included several steel types that have been rather extensively used
for the present purpose. Other compositions will be considered for
inclusion by the committee from time to time as the need becomes
apparent.
Note 2:?For grades of alloy-steel bolting suitable for use at
the lower range of high temperature applications, reference should
be made to Specification A354.
Note 3:?For grades of alloy-steel bolting suitable for use in
low temperature applications, reference should be made to
Specification A320/A320M.
1.4?Nuts for use with bolting are covered in Section 13. 1.5?Supplementary Requirements are provided for use at the option of the purchaser. The supplementary requirements shall apply only when specified in the purchase order or contract. 1.6?This specification is expressed in both inch-pound units and in SI units; however, unless the purchase order or contract specifies the applicable 1.7?The values stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. 1.8?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
| 2. Referenced Documents | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
Doporučujeme:
Aktualizace zákonů
Chcete mít jistotu o platnosti užívaných předpisů?
Nabízíme Vám řešení, abyste mohli používat stále platné (aktuální) legislativní předpisy.
Chcete vědět více informací? Podívejte se na tuto stránku.
