Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Specification for High Strength Precipitation Hardening and Duplex Stainless Steel Bolting for Special Purpose Applications
Automaticky přeložený název:
Standardní specifikace pro vysokou pevností srážek kalení a Duplex nerezové oceli vybíhání pro zvláštní účely aplikace
NORMA vydána dne 15.11.2012
Označení normy: ASTM A1082/A1082M-12
Poznámka: NEPLATNÁ
Datum vydání normy: 15.11.2012
Kód zboží: NS-1307
Počet stran: 6
Přibližná hmotnost: 18 g (0.04 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
age-hardening stainless steel, bolts&ndash,stainless steel, duplex stainless steel, fasteners&ndash,stainless steel, high strength stainless steels, marking, nuts, precipitation hardening stainless steel, stainless steel bars, stainless steel fasteners, ICS Number Code 77.080.20 (Steels)
1. Scope | ||||||||||||||
1.1 This specification covers high strength stainless steel bolting for special purpose applications such as pressure vessels. Several grades of precipitation-hardened and duplex (ferritic-austenitic) stainless steels are covered. Selection will depend upon design, service conditions, mechanical properties and characteristics related to the application. 1.2 The following referenced general requirements are indispensable for application of this specification: Specification A962/A962M. 1.3 Supplementary Requirements are provided for use at the option of the purchaser. The Supplementary Requirements shall only apply when specified individually by the purchaser in the purchase order or contract. 1.4 This specification is expressed in both inch-pound units and in SI units; however, unless the purchase order or contract specifies the applicable “M” specification designation (SI units), the inch-pound units shall apply. 1.5 The values stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. 1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||||||
2. Referenced Documents | ||||||||||||||
|
Poslední aktualizace: 08.09.2024 (Počet položek: 2 346 102)
© Copyright 2024 NORMSERVIS s.r.o.