Cookies
Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
ASTM A1064/A1064M-18a
Standard Specification for Carbon-Steel Wire and Welded Wire Reinforcement, Plain and Deformed, for Concrete (Includes all amendments And changes 11/21/2022).
Přeložit název
NORMA vydána dne 15.11.2018
Informace o normě:
Označení normy: ASTM A1064/A1064M-18a
Poznámka: NEPLATNÁ
Datum vydání normy: 15.11.2018
Kód zboží: NS-906319
Počet stran: 10
Přibližná hmotnost: 30 g (0.07 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Kategorie - podobné normy:
Anotace textu normy ASTM A1064/A1064M-18a :
Keywords:
concrete reinforcement, deformations, deformed wire, reinforced concrete, reinforcing steels, steel wire, welded wire reinforcement ,, ICS Number Code 77.140.15 (Steels for reinforcement of concrete)
Doplňující informace
| 1. Scope | ||||||||||
|
1.1 This specification covers carbon-steel wire and welded wire reinforcement produced from hot-rolled rod to be used for the reinforcement of concrete. The steel wire is cold-worked, drawn or rolled, plain (non-deformed, as-drawn or galvanized), or deformed. Welded wire reinforcement is made from plain or deformed wire, or a combination of plain and deformed wire. Common wire sizes and dimensions are given in Table 1, Table 2, Table 3, and Table 4. Actual wire sizes are not restricted to those shown in the tables. Note 1: Welded wire for concrete reinforcement has
historically been described by various terms: welded wire fabric,
WWF, fabric, and mesh. The wire reinforcement industry has adopted
the term 1.2 The values stated in either
inch-pound units or SI units are to be regarded separately as
standard. Within the text the SI units are shown in brackets
(except in Table 2 and
Table 4). The values stated
in each system may not be exact equivalents; therefore, each system
shall be used independently of the other. Combining values from the
two systems may result in non-conformance with this
specification.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||
| 2. Referenced Documents | ||||||||||
|
Doporučujeme:
