Cookies
Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
ASTM A1064/A1064M-17
Standard Specification for Carbon-Steel Wire and Welded Wire Reinforcement, Plain and Deformed, for Concrete
Přeložit název
NORMA vydána dne 15.3.2017
Informace o normě:
Označení normy: ASTM A1064/A1064M-17
Poznámka: NEPLATNÁ
Datum vydání normy: 15.3.2017
Kód zboží: NS-678694
Počet stran: 11
Přibližná hmotnost: 33 g (0.07 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Kategorie - podobné normy:
Anotace textu normy ASTM A1064/A1064M-17 :
Keywords:
concrete reinforcement, deformations, deformed wire, reinforced concrete, reinforcing steels, steel wire, welded wire reinforcement ,, ICS Number Code 77.140.15 (Steels for reinforcement of concrete)
Doplňující informace
| 1. Scope | ||||||||||
|
1.1 This specification covers carbon-steel wire and welded wire reinforcement produced from hot-rolled rod to be used for the reinforcement of concrete. The steel wire is cold-worked, drawn or rolled, plain (non-deformed, as-drawn or galvanized), or deformed. Welded wire reinforcement is made from plain or deformed wire, or a combination of plain and deformed wire. Common wire sizes and dimensions are given in Table 1, Table 2, Table 3, and Table 4. Actual wire sizes are not restricted to those shown in the tables. Note 1: Welded wire for concrete reinforcement has
historically been described by various terms: welded wire fabric,
WWF, fabric, and mesh. The wire reinforcement industry has adopted
the term 1.2 The values stated in either
inch-pound or SI units are to be regarded separately as standard.
Within the text the SI units are shown in brackets (except in
Table 2 and Table 4). The values stated in each
system are not exact equivalents; therefore, each system must be
used independently of the other. Combining values may result in
nonconformance with the specification.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||
| 2. Referenced Documents | ||||||||||
|
Doporučujeme:
