Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Speed Governing Systems for Hydraulic Turbine Generator Units
Přeložit název
NORMA vydána dne 2005
Označení normy: ASME PTC29:2005(R2020)
Datum vydání normy: 2005
Kód zboží: NS-999321
Počet stran: 46
Přibližná hmotnost: 138 g (0.30 liber)
Země: Americká technická norma
Kategorie: Technické normy ASME
This Code applies to speed governors used on conventional, constant-speed hydraulic turbines. This Code is applicable to electronic-hydraulic and mechanical-hydraulic speed governors. These governors are commonly used to control reaction and impulse-type-hydraulic turbines (fixed or variable geometry) and pump turbines operating in generation mode. This Code specifies procedures for conducting tests to determine the following performance characteristics of hydraulic turbine speed governors: (a) droop: (1) permanent, (2) temporary; (b) deadband and deadtime: (1) speed, (2) position, (3) power; (c) stability index: (1) governing speedband, (2) governing powerband; (d) step response; (e) gain: (1) proportional gain, (2) integral gain, (3) derivative gain; (f) setpoint adjustment: (1) range of adjustment, (2) ramp rate. This Code also establishes the rules and procedures for the conduct of tests to determine the following operational characteristics of hydraulic turbine speed governors: (a) gate/blade relationship (dual regulated reaction turbines), (b) needle/deflector relationship (impulse turbines), (c) full-rate servomotor timing and cushion time.
Desc: PTC 29
ISBN: 0791829510
Reaffirmed: 2020
Poslední aktualizace: 28.07.2024 (Počet položek: 2 339 194)
© Copyright 2024 NORMSERVIS s.r.o.