NORMSERVIS s.r.o.

ASTM D6788-24

Standard Specification for Repositionable Pressure-Sensitive Flags

NORMA vydána dne 1.3.2024

Anglicky -
PDF - okamžité stažení (1275.10 CZK)

Anglicky -
PDF + redline - ihned (1530.20 CZK)

Anglicky -
Tištěné (1275.10 CZK)

Anglicky -
Tisk + redline (1530.20 CZK)


Proč Redline?

Redline představuje rychlý a snadný způsob jak porovnat všechny změny mezi aktuální platnou normou a předchozí verzí.

Díky redline se okamžitě dozvíte o:

Ušetřete si čas i starosti!

Díky Redline již nebudete muset ztrácet čas zjišťováním, co se v nové normě změnilo. Redline Vám ušetří čas a zaručí, že se o změnách v normě dozvíte.

Cena

Pokud si zvolíte možnost "Platná norma + Redline", pak dostanete oba dokumenty! A co je nejlepší, cena Platné normy + Redline je pouze o něco málo vyšší než cena samostatné platné normy.

Zobrazit ukázku Redline

Informace o normě:

Označení normy: ASTM D6788-24
Datum vydání normy: 1.3.2024
Počet stran: 4
Přibližná hmotnost: 12 g (0.03 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM

Anotace textu normy ASTM D6788-24 :

This specification covers repositionable pressure-sensitive flags used to mark, flag, and index documents, books, periodicals, and so forth. Flags covered here consist of a single sheet of matte film partially covered by adhesive. A non-adhesive tab or section at one end of the flag serves for easy removal from most surfaces, including paper. The backing shall consist of polyester, polypropylene, or polyethylene film, and shall have a transparent matte surface on one side that is writable by pens and pencils. Flags are available in the following types: Type 1, which are of specified width, and have a colored tab at one end; Type 2, which are of the same width as Type 1, and have a printed message on the top side of the flag; Type 3, which twice the width of Type 1, and have a white tab at one end to highlight writing; Type 4, which are half the width of Type 1, and have a colored tab at one end; and Type 5, which are half the width of Type 1, and have an arrow or a message printed on the top side of the flag. Sampled specimens shall conform to physical requirements in terms of minimum and maximum adhesion, dispension force, and thickness.


Keywords:
flags, index, pressure-sensitive adhesive, repositionable,, ICS Number Code 83.180 (Adhesives)