|ASTM F894-06 - 15.8.2006|
1.1 This specification covers requirements and test methods for materials, dimensions, workmanship, ring stiffness, flattening, joint systems, and a form of marking for large diameter, 10 to 120 in. (250 to 3050 mm), inside diameter based polyethylene (PE) pipe of profile wall construction and with butt-fused, bell and spigot, and other mechanical joints for use in low pressure and gravity flow applications, such as for sewers and drains. Note 1Pipe produced to this specification should be installed in accordance with Practice D 2321 and with the manufacturer's recommendations.
For purposes of this specification, low pressure is defined as 50 ft (15.2 m) of water column or less.
1.2 The values stated in inch-pound units are to be regarded as the standard. The values in parentheses are provided for information only.
|2. Referenced Documents|