1.1 This specification establishes the requirements for wrought and fabricated shapes made from Copper UNS No. C10100, conforming to the chemical requirements of Specification B170, Grade 1, and suitable for use in electron devices. 1.2 The requirements of this specification are in addition to those prescribed in the following product specifications appropriate to the material being ordered: B1, B2, B3, B75, B75M, B152/B152M, B170, B187/B187M, , B272, and B372. In case of conflict, however, this specification shall take precedence. 1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.3.1 Exception—grain sizes are in metric units and are standard. 1.4 The following safety hazard caveat applies to sections 17.4, 17.5 and 18.7 of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
B187/B187M-20 | Standard Specification for Copper, Bus Bar, Rod, and Shapes and General Purpose Rod, Bar, and Shapes |
B188-15(2023) | Standard Specification for Seamless Copper Bus Pipe and Tube |
B193-20 | Standard Test Method for Resistivity of Electrical Conductor Materials |
B272-12(2019) | Standard Specification for Copper Flat Products with Finished (Rolled or Drawn) Edges (Flat Wire and Strip) |
B372-22 | Standard Specification for Seamless Copper and Copper-Alloy Rectangular Waveguide Tube |
B577-19 | Standard Test Methods for Detection of Cuprous Oxide (Hydrogen Embrittlement Susceptibility) in Copper |
B846-19a | Standard Terminology for Copper and Copper Alloys (Includes all amendments and changes 8/8/2019). |
E29-22 | Standard Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications |
E112-13(2021) | Standard Test Methods for Determining Average Grain Size |
E527-23 | Standard Practice for Numbering Metals and Alloys in the Unified Numbering System (UNS) |
| Comparison Chart Available from ASTM International Headquarters. Order Adjunct No. . Original adjunct produced in 1966. |
B1-13(2018) | Standard Specification for Hard-Drawn Copper Wire |
B2-13(2018) | Standard Specification for Medium-Hard-Drawn Copper Wire |
B3-13(2018) | Standard Specification for Soft or Annealed Copper Wire |
B75/B75M-20 | Standard Specification for Seamless Copper Tube |
B152/B152M-19 | Standard Specification for Copper Sheet, Strip, Plate, and Rolled Bar |
B170-99(2020) | Standard Specification for Oxygen-Free Electrolytic Copper´Refinery Shapes |
|