ASTM F585-94(2000) - 1.1.2000
 
1. Scope

1.1 This practice describes design and selection considerations and installation procedures for the construction of new sanitary and storm sewers by the insertion of polyethylene pipe through existing pipe and along the previously existing line and grade. The procedures are designed to minimize traffic disruption, surface damage, and restoration, with little or no interruption of service.

Note 1--See CGSB 41-GP-25M.

1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

 
2. Referenced Documents

PPI

Material Handling Guide

F2620-20ae2

Standard Practice for Heat Fusion Joining of Polyethylene Pipe and Fittings (Includes all amendments and changes 3/17/2022).

F1804-21

Standard Practice for Determining Allowable Tensile Load for Polyethylene (PE) Gas Pipe During Pull-In Installation

F1417-11A(2019)e1

Standard Practice for Installation Acceptance of Plastic Non-pressure Sewer Lines Using Low-Pressure Air (Includes all amendments and changes 5/13/2020).

F412-23

Standard Terminology Relating to Plastic Piping Systems