ASTM D1710-15(2021) - 1.10.2021
 
1. Scope

1.1?This specification covers extruded polytetrafluoroethylene (PTFE) rod, heavy-walled tubing, and basic shapes manufactured from the PTFE resin of Specification D4894 and reprocessed PTFE resin (as defined in Guide D7209).

1.2?The specification covers all sizes of rod, tubing, and basic shapes with a wall thickness of 1.6 mm (1/16?in.) or greater. These materials must be made wholly from PTFE and produced in accordance with good commercial ram extrusion practices.

Note 1:?This specification and ISO/DIS 13000-1 (1997) and ISO/DIS 13000-2 (1997) differ in approach, however, data obtained using either are technically equivalent.

Note 2:?For compression molded PTFE materials, see Specification D3294. Material that can be certified to Specification D3294 may be substituted for Specification D1710, however the reverse in not true.

1.3?The values stated in SI units, as detailed in IEEE/ASTM SI 10 are to be regarded as the standard. The inch-pound units given in parentheses are provided for information only.

1.4?The following precautionary caveat pertains to the test methods portion, Section 12, only of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

 
2. Referenced Documents

D149-20

Standard Test Method for Dielectric Breakdown Voltage and Dielectric Strength of Solid Electrical Insulating Materials at Commercial Power Frequencies

IEEE/ASTM SI 10

Standard for the Use of the International System of Units (SI): The Modern Metric System Available from ASTM International, 100 Barr Harbor Drive, West Conshohocken, PA 19428.

D5947-18

Standard Test Methods for Physical Dimensions of Solid Plastics Specimens

D4894-19

Standard Specification for Polytetrafluoroethylene (PTFE) Granular Molding and Ram Extrusion Materials

D3892-15(2020)

Standard Practice for Packaging/Packing of Plastics

D792-20

Standard Test Methods for Density and Specific Gravity (Relative Density) of Plastics by Displacement

D618-21

Standard Practice for Conditioning Plastics for Testing

D374-99

Standard Test Methods for Thickness of Solid Electrical Insulation

D5740-18

Standard Guide for Writing Material Standards in the Classification D4000 Format

D1600-18

Standard Terminology for Abbreviated Terms Relating to Plastics (Withdrawn 2024)

D883-24

Standard Terminology Relating to Plastics

E94-04

Standard Guide for Radiographic Examination

ISO 13000-2 (2005)

PlasticsPolytetrafluoroethylene (PTFE) Semi-Finished Products, Part 2: Preparation of Test Specimen and Determination of Properties

ISO 13000-1 (2005)

PlasticsPolytetrafluoroethylene (PTFE) Semi-Finished Products, Part 1: Basis for Specification

D7209-06

Standard Guide for Waste Reduction, Resource Recovery, and Use of Recycled Polymeric Materials and Products (Withdrawn 2015)