ASTM C1450/C1450M-04(2019) - 1.2.2019
 
1. Scope

1.1 This specification covers non-asbestos fiber-cement pipe intended for use in storm-water drainage of highways, airports, farms, foundations, and other similar drainage systems.

1.2 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.

Note 1: Experience has shown that the successful performance of this product depends upon the proper selection of the pipe strength, the type of bedding and backfill, care that the installation conforms to the construction specifications, and provision for adequate inspection at the construction site. This specification does not include requirements for bedding, backfill, the relationship between field load conditions and the strength designation of the pipe, or durability. These requirements should be included in the project specification.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

 
2. Referenced Documents

Fed. Std. No. 123

Marking for Shipment and (Civil Agencies) Available from Standardization Documents Order Desk, Bldg. 4, Section D, 700 Robbins Ave., Philadelphia, PA 19111-5904 Attn: NPODS.

MIL-STD-105

Sampling Procedures and Tables for Inspection by Attributes Available from the Uniform Classification Commission, Room 1106, 222 S, Riverside Plaza, Chicago, IL 60606.

ISO?390:

1993 Products in Fibre Reinforced Cement--Sampling and Inspection Available from International Organization for Standardization (ISO), 1 rue de Varemb, Case postale 56, CH-1211, Geneva 20, Switzerland.

National Motor Freight Classification Rules Available from National Motor Freight Inc., 1616 “P” St. NW, Washington, DC 20036.

ISO?2859 –1:

1999 Sampling Procedures for Inspection by Attributes Part 1: Sampling Schemes Indexed by Acceptance Quality Limit (AQL) for Lot-by-Lot Inspection

MIL-STD-129

Marking for Shipment and Storage

MIL-STD-414

Sampling Procedures and Tables for Inspection by Variables for Percent Defective

Uniform Freight Classification Rules

ISO?3951:

1989 Sampling Procedures and Charts for Inspection by Variables for Percent Nonconforming

C500-07

Standard Test Methods for Asbestos-Cement Pipe

C595-08

Standard Specification for Blended Hydraulic Cements

C1154-24

Standard Terminology for Fiber-Reinforced Cement Products

C150-07

Standard Specification for Portland Cement

C497-20e1

Standard Test Methods for Concrete Pipe, Concrete Box Sections, Manhole Sections, or Tile (Includes all amendments and changes 11/2/2020).