ASTM C1172-19 - 1.2.2019
 
1. Scope

1.1 This specification covers the quality requirements of flat laminated glass consisting of two or more lites of glass bonded with an interlayer material for use in building and related applications.

1.2 Depending on the number, thickness, and treatment of lites, and the number and thickness of interlayers, the glass shall be laminated for applications including, but not limited to, safety, security, detention, hurricane/cyclic-wind resistance, blast resistance, bullet resistance, sound reduction, and decorative glazing.

1.3 Optical distortion and the evaluation thereof are not currently within the scope of the standard. Mockups are recommended as a method to evaluate glass. (See Appendix X1.)

1.4 The dimensional values, except thickness designations, stated in inch-pound units are to be regarded as the standard. The values in parentheses are for information only.

1.5 The following safety hazards caveat pertains only to the test method portion, Section 7, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

 
2. Referenced Documents

C1503-24

Standard Specification for Silvered Flat Glass Mirror

E308-22

Standard Practice for Computing the Colors of Objects by Using the CIE System

E413-22

Classification for Rating Sound Insulation

E903-20

Standard Test Method for Solar Absorptance, Reflectance, and Transmittance of Materials Using Integrating Spheres

E1996-23

Standard Specification for Performance of Exterior Windows, Curtain Walls, Doors, and Impact Protective Systems Impacted by Windborne Debris in Hurricanes

E2395-21

Standard Specification for Voluntary Security Performance of Window and Door Assemblies with Glazing Impact

F1233-21

Standard Test Method for Security Glazing Materials And Systems

F1642-12

Standard Test Method for Glazing and Glazing Systems Subject to Airblast Loadings

F1915-05(2019)

Standard Test Methods for Glazing for Detention Facilities

F3006-20

Standard Specification for Ball Drop Impact Resistance of Laminated Architectural Flat Glazing

F3007-19

Standard Test Method for Ball Drop Impact Resistance of Laminated Architectural Flat Glass

E1332-22

Standard Classification for Rating Outdoor-Indoor Sound Attenuation

E1886-19

Standard Test Method for Performance of Exterior Windows, Curtain Walls, Doors, and Impact Protective Systems Impacted by Missile(s) and Exposed to Cyclic Pressure Differentials

UL 972

Standard for Burglary Resisting Glazing Materials

UL 752

Standard for Bullet Resisting Materials

NIJ 0108.1

Ballistic Resistant Protective Materials

Z97.1

Safety Glazing Materials Used in Buildings--Safety Performance Specifications and Methods of Tests Available from American National Standards Institute (ANSI), 25 W. 43rd St., 4th Floor, New York, NY 10036, http://www.ansi.org.

C1422-99

Standard Specification for Chemically Strengthened Flat Glass

C1376-21a

Standard Specification for Pyrolytic and Vacuum Deposition Coatings on Flat Glass (Includes all amendments and changes 11/10/2021).

C1048-18

Standard Specification for Heat-Strengthened and Fully Tempered Flat Glass

C1036-21

Standard Specification for Flat Glass

CPSC 16CFR1201

Consumer Product Safety Commission Safety Standard for Architectural Glazing Materials

C162-23

Standard Terminology of Glass and Glass Products