ASTM A775/A775M-19 - 1.6.2019
 
1. Scope

1.1 This specification covers deformed and plain steel reinforcing bars with protective epoxy coating applied by the electrostatic spray method.

Note 1: The coating applicator is identified throughout this specification as the manufacturer.

1.2 Other organic coatings may be used provided they meet the requirements of this specification.

1.3 Requirements for coatings are contained in Annex A1.

1.4 Requirements for patching material are contained in Annex A2.

1.5 Guidelines for construction practices at the job-site are presented in Appendix X1.

1.6 This specification is applicable for orders in either inch-pound units (as Specification A775) or SI units [as Specification A775M].

1.7 The values stated in either inch-pound units or SI units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.8 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.9 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

 
2. Referenced Documents

SSPC-PA2

ACI301

Specifications for Structural Concrete

SSPC-VIS1

G8

Test Methods for Cathodic Disbonding of Pipeline Coatings

A615/A615M

Specification for Deformed and Plain Carbon-Steel Bars for Concrete Reinforcement

A706/A706M

Specification for Deformed and Plain Low-Alloy Steel Bars for Concrete Reinforcement

A944

Test Method for Comparing Bond Strength of Steel Reinforcing Bars to Concrete Using Beam-End Specimens

A996/A996M

Specification for Rail-Steel and Axle-Steel Deformed Bars for Concrete Reinforcement

B117

Practice for Operating Salt Spray (Fog) Apparatus

D374

Test Methods for Thickness of Solid Electrical Insulation

D2967

Test Method for Corner Coverage of Powder Coatings

D4060

Test Method for Abrasion Resistance of Organic Coatings by the Taber Abraser

RP-287-87

Field Measurement of Surface Profile of Abrasive Blast-Cleaned Steel Surface Using a Replica Tape

G14

Test Method for Impact Resistance of Pipeline Coatings (Falling Weight Test)

G62

Test Methods for Holiday Detection in Pipeline Coatings

G20

Test Method for Chemical Resistance of Pipeline Coatings

Near-White Blast Cleaning