Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Methods for Determination of Gold in Cyanide Solutions
Automaticky přeložený název:
Standardní zkušební metody pro stanovení zlata v kyanidu Solutions
NORMA vydána dne 1.4.2015
Označení normy: ASTM E1600-15
Poznámka: NEPLATNÁ
Datum vydání normy: 1.4.2015
Kód zboží: NS-588599
Počet stran: 8
Přibližná hmotnost: 24 g (0.05 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
cyanide solutions, flame atomic absorption spectrometry, gold concentration, inductively coupled plasma mass spectrometry,, ICS Number Code 73.060.99 (Other metalliferrous minerals)
Significance and Use | ||||||||||||||||||||||||||
4.1 In primary metallurgical processes for gold bearing ores, gold is extracted with an alkaline cyanide solution. Metallurgical accounting, process control, and ore evaluation procedures depend on accurate, precise, and prompt measurements of the gold concentrations. 4.2 These test methods are comparative referee methods for compliance with compositional specifications for metal concentration or to monitor processes. It is assumed that all who use these methods will be trained analysts capable of performing common laboratory procedures skillfully and safely. It is expected that work will be performed in a properly equipped laboratory under appropriate quality control practices such as those described in Guide E882, and that proper waste disposal procedures will be followed. |
||||||||||||||||||||||||||
1. Scope | ||||||||||||||||||||||||||
1.1 These test methods cover the determination of gold in ore processing cyanide solutions within the following ranges:
Note 1: The lower limit for the Inductively Coupled Plasma
Mass Spectrometry Method, 0.001 µg/mL, was set following the
guidance of Practice E1601.
The reproducibility Index, R, was calculated using the total
standard deviation for the lowest concentration Youden pair
solution.
1.1.1 These test methods may also be applied to cyanide leach solutions from metallurgical evaluation procedures. 1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.3 The test methods appear in the following order:
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific precautions are given in 11.1, 11.1.1, 11.5, and 12.2. |
||||||||||||||||||||||||||
2. Referenced Documents | ||||||||||||||||||||||||||
|
Chcete mít jistotu, že používáte pouze platné technické normy?
Nabízíme Vám řešení, které Vám zajistí měsíční přehled o aktuálnosti norem, které používáte.
Chcete vědět více informací? Podívejte se na tuto stránku.
Poslední aktualizace: 23.04.2024 (Počet položek: 2 895 375)
© Copyright 2024 NORMSERVIS s.r.o.