Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Specification for Non-Aqueous Engine Coolant for Automobile and Light-Duty Service
Přeložit název
NORMA vydána dne 1.1.2017
Označení normy: ASTM D8085-17
Datum vydání normy: 1.1.2017
Kód zboží: NS-673843
Počet stran: 5
Přibližná hmotnost: 15 g (0.03 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
This specification establishes the requirements for nonaqueous engine coolants used in automobiles or other lightduty service cooling systems. Non-aqueous coolants that conform to the specification will function effectively to provide protection against freezing, boiling, and corrosion without any further dilution. This specification is based upon the knowledge of the performance of non-aqueous engine coolants prepared from new individual or mixtures of virgin industrial grade diols.This specification covers general requirements (color, effect on nonmetals), physical and chemical requirements (relative density, dynamic viscosity, boiling point, thermal conductivity, flash point, ash content, pH, chloride, water, reserve alkalinity, effect on automotive finish [use clear coat thermoset urethane or acrylic urethane finish]), and performance requirements (corrosion in glassware, simulated service test, corrosion of cast aluminum alloys at heat-rejecting surfaces [mg/cm2/week], foaming).
Keywords:
light duty engine coolant, non-aqueous engine coolant, waterless engine coolant,, ICS Number Code 43.040.01 (Road vehicle systems in general)
1. Scope | ||||||||||||||||||||||||||||||||||||||
1.1 This specification covers the requirements for non-aqueous engine coolants used in automobiles or other light-duty service cooling systems. Non-aqueous coolants that conform to the specification will function effectively to provide protection against freezing, boiling, and corrosion without any further dilution. This specification is based upon the knowledge of the performance of non-aqueous engine coolants prepared from new individual or mixtures of virgin industrial grade diols. 1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. See X1.4 for a specific warning statement. |
||||||||||||||||||||||||||||||||||||||
2. Referenced Documents | ||||||||||||||||||||||||||||||||||||||
|
Chcete mít jistotu, že používáte pouze platné technické normy?
Nabízíme Vám řešení, které Vám zajistí měsíční přehled o aktuálnosti norem, které používáte.
Chcete vědět více informací? Podívejte se na tuto stránku.
Poslední aktualizace: 26.04.2024 (Počet položek: 2 896 057)
© Copyright 2024 NORMSERVIS s.r.o.