Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Guide for Sampling Plan and Core Sampling of Carbon Cathode Blocks Used in Aluminum Production
Automaticky přeložený název:
Standardní Průvodce pro plán odběru vzorků a jádrové vrty z uhlíkových Cathode bloky použité při výrobě hliníku
NORMA vydána dne 15.4.2012
Označení normy: ASTM D6354-12
Poznámka: NEPLATNÁ
Datum vydání normy: 15.4.2012
Kód zboží: NS-34801
Počet stran: 4
Přibližná hmotnost: 12 g (0.03 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
anthracite, carbon, cathodes, core, graphite, sample, sampling, test specimens, Aluminum, Aluminum industry, Anthracite, Carbon cathode blocks, Cathode carbon, Core sampling, Graphite, Sampling metals/alloys, ICS Number Code 77.020 (Production of metals)
Significance and Use | ||||||||||||||||
Core sampling is an acceptable way of obtaining a test specimen without destroying the usefulness of a cathode block. Test specimens obtained by this guide can be used by producers and users of cathode blocks for the purpose of conducting the tests in Note 1 to obtain comparative physical properties. Sampling shall not weaken the cathode block or increase the likelihood of premature failure. Extreme care shall be exercised when taking vertically drilled samples. |
||||||||||||||||
1. Scope | ||||||||||||||||
1.1 This guide covers sampling of carbon cathode blocks used in the production of aluminum, and details procedures for taking samples from single cathode blocks. It covers equipment and procedures for obtaining samples from cathode blocks in a manner that does not destroy the cathode block or prevent its subsequent use as originally intended. However, the user must determine the subsequent use of the sampled cathode blocks. Preferred locations for taking samples from single units of cathode blocks are covered in this guide. 1.1.1 Information for sampling of shaped refractory products, in general, is given in ISO 5022. This standard details the statistical basis for sampling plans for acceptance testing of a consignment or lot. Cathode blocks used in the production of aluminum have specific requirements of sampling, and while the statistical basis for sampling given in ISO 5022 applies, further or modified requirements may also apply. 1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Note 1—The following ASTM standards are noted as sources of useful information: Test Methods C559, C611, C651, C747, C1025, C1039, and C1225. |
||||||||||||||||
2. Referenced Documents | ||||||||||||||||
|
Historická
1.10.2007
Historická
1.5.2011
Historická
1.5.2010
Historická
1.5.2010
Historická
1.6.2014
Historická
1.6.2014
Poslední aktualizace: 03.05.2024 (Počet položek: 2 896 946)
© Copyright 2024 NORMSERVIS s.r.o.