Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Method for Measurement of Dry-Film Thickness of Organic Coatings Using Micrometers
Automaticky přeložený název:
Standardní zkušební metoda pro měření suchého filmu tloušťky nátěrových hmot Použití Mikrometry
NORMA vydána dne 1.7.2013
Označení normy: ASTM D1005-95(2013)
Poznámka: NEPLATNÁ
Datum vydání normy: 1.7.2013
Kód zboží: NS-16056
Počet stran: 3
Přibližná hmotnost: 9 g (0.02 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
dial comparator, dial indicator, dial indicator gage, film&mdash,dry film thickness, measurement of organic coatings, micrometer, ICS Number Code 25.220.60 (Organic coatings)
Significance and Use | ||||
3.1 This test method is particularly applicable to the measurement of free films and is also satisfactory for the measurement of films on laboratory test panels. 3.2 The accuracy and precision of the thickness measurements may be influenced by the deformability of the coating. This test method is not applicable to coatings that are readily deformable under the load of the measuring instrument. 3.3 The accuracy and precision of the thickness measurements are also influenced by the uniformity of the substrate when the coatings are applied to laboratory test panels. |
||||
1. Scope | ||||
1.1 This test method covers the measurement of film thickness of dried films of paint, varnish, lacquer, and related products using micrometers. Procedures A and B utilize stationary micrometers and Procedures C and D, hand-held micrometers. Procedures A and C are not recommended for films less than 12.5 μm (0.5 mils) in thickness. The minimum thickness required for Procedures B and D is a function of that required to enable removal of the sample as a free film. 1.2 The procedures appear as follows: 1.2.1 Procedure A—Stationary micrometer for measuring coatings applied to plane rigid surfaces. 1.2.2 Procedure B—Stationary micrometer for measuring free films. 1.2.3 Procedure C—Hand-held micrometer for measuring coatings applied to plane rigid surfaces. 1.2.4 Procedure D—Hand-held micrometer for measuring free films. 1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.4 This standard does not purport to address the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||
2. Referenced Documents | ||||
|
Historická
1.6.2013
Historická
1.11.2012
Historická
15.5.2013
Historická
1.12.2010
Historická
1.11.2012
Historická
1.6.2011
Poslední aktualizace: 31.10.2024 (Počet položek: 2 208 647)
© Copyright 2024 NORMSERVIS s.r.o.